Jump-Starting - Yamaha WOLVERINE YXE70WPXH Owner's Manual

To install the battery
TIP
Be sure the battery is fully charged.
1. Place the battery in its compartment.
2. Connect the positive battery lead first,
then the negative battery lead by install-
ing their bolt. NOTICE: When installing
the battery, the main switch must be
off, and the positive lead must be con-
nected before the negative lead.
8
1
1. Positive battery lead (red)
2. Battery band
3. Negative battery lead (black)
[ECB01111]
2
3
3. Hook the battery bands.
4. Install the air intake duct panel by install-
ing the quick fastener screws.
5. Install the hood.
EBU32650

Jump-starting

Jump-starting the vehicle should be avoided.
The battery should be removed and charged
instead.
EWB03430
WARNING
To avoid battery explosion and/or serious
damage to the electrical system:
 Do not connect the negative lead of the
jumper cable to the negative terminal of
the battery.
 Do not touch the positive lead of the
jumper cable to the negative lead.
 Do not reverse the polarity of the jumper
cables when connecting to the batteries.
However, if the vehicle must be jump-started,
proceed as follows.
8-50