1
2
1. Coolant reservoir cap
2. Coolant reservoir hose
8. Disconnect the coolant reservoir hose,
and then drain the coolant from the cool-
ant reservoir.
9. After draining the coolant, thoroughly
flush the cooling system with clean tap
water.
10. Install the coolant drain bolt and its new
gasket and then tighten the bolt to the
specified torque.
Tightening torque:
Coolant drain bolt:
8 N·m (0.8 kgf·m, 5.8 lb·ft)
11. Connect the coolant reservoir hose.
12. Pour the recommended coolant into the
radiator until it is full.
13. Pour the recommended coolant into the
reservoir to the maximum level mark, and
then install the reservoir cap.
ECB02190
NOTICE
Mix antifreeze with distilled water only.
However, if distilled water is not available,
soft water may be used for refilling. Do not
use hard water or salt water since they are
harmful to the engine.
8-27
8