Axle Boots - Yamaha WOLVERINE YXE70WPXH Owner's Manual

1
1. Cylinder head air bleed bolt
18. When coolant begins to flow out of the
bolt hole, tighten the cylinder head air
bleed bolt to the specified torque.
Tightening torque:
Cylinder head air bleed bolt:
10 N·m (1.0 kgf·m, 7.2 lb·ft)
19. Start the engine and let it idle for ten mi-
nutes.
20. Rev the engine five times.
21. Pour additional coolant into the radiator
until it is full.
22. Stop the engine and allow it to cool. If the
coolant level has dropped after the en-
gine has cooled, add sufficient coolant
until it reaches the top of the radiator, and
then install the radiator cap.
23. Check the coolant level in the reservoir. If
necessary, remove the coolant reservoir
cap, add coolant to the maximum level
mark, and then install the cap.
24. Start the engine, and then check for cool-
ant leakage.
TIP
If any leakage is found, have a Yamaha dealer
check the cooling system.
25. Install the panels and the hood.
EBU32400

Axle boots

Check the axle boots for holes or tears.
If any damage is found, have them replaced
by a Yamaha dealer.
8-29
8