Bowflex TC1000 Assembly Manual page 6

Locate the following for this step:
PARTS:
TreadClimber® Base & Treadle Assembly from
Step 9.
HARDWARE:
Two (2) 5/16" x 1-1/2" Button Head Screws
Two (2) 5/16" Acorn Nuts
Two (2) 5/16" x 1" Button Head Screws
Two (2) 5/16" Flat Washers
TOOLS:
3/16" Hex Key (included)
9/16" Open End Wrench (included)
First bolt the dial end of the cylinders to the
uprights using (1) 5/16" x 1-1/2" button head
screw and (1) 5/16" acorn nut, per side.
Tighten with the provided 9/16" open end
wrench and 3/16" hex key (see Figure 10-1).
Make sure that the white arrows located on the
Workout Level Setting Dials at the top of the
Hydraulic Cylinders face the rear of the
machine where you can easily see them during
your workout.
Starting on the right side, pull the cylinder down
and place the eyelet on the Cylinder Stud
protruding from the treadles. Attach the
hydraulic cylinder using (1) 5/16" x 1" button
head screws and (1) 5/16" flat washers (see
Figure 10-2).
Repeat this process on the left side.
NOTE: If having difficulty placing hydraulic
cylinder(s) on treadle stud, loosen lower upright
screws, place cylinder on the stud and retighten
the upright screws.
11-1 Remove the protective plastic film from
the console face. Inspect all attachments you
have made thus far and tighten all bolts
securely before proceeding to Step 12.
I N S T A L L I N G S T E P S
Step 10: ATTACHING THE HYDRAULIC CYLINDERS
Step 11: INSPECTING ASSEMBLY
Figure 10-1
Figure 10-2
6