- Pulling out the Drain Hose from outlet to remove the Discharge
Grille.
(Fig.
5)
- Removing the right and left screws.
- Then remove the Control Board by pressing down the hook at the
left and pushing up the right hook.
- Release the Fan Motor leadwire by pressing the hook at the center
of the connector.
- Remove the screw at the Cross Flow Fan.
- REMINDER - To reinstall the Fan Motor, adjust the connector of the
Fan Motor as shown in the
(Fig.
6)
Fig.
7.
Fig. 5
Fig. 6
Fig. 7
54
(Fig.
5)
(Fig.
5)
(Fig.
7)