Table of Contents
Advertisement
Trouble-shooting Answer to question
If the laundries fall to the outer side of the spin tub
If the laundries fall to the outer side of the spin tub,
please take them out immediately.
1.Dismantle
As indicated in the figure, push the point marked
with " " to pull the spin tub frame to oblique
upwards to dismantle it.
2.Install
After install the back edge of the spin tub frame to
proper position, push the four points marked with
" " by force to reset it.
Please check carefully. The laundries may fall to
the lower part of the outer side of the spin tub
(as indicated in the figure).
If the laundries fall to the outer side of the spin
tub, during spinning the draining will get blocked
and the rotation speed of the spin tub is reduced.
When the remained water is frozen
Prevent the freezing (be sure to discharge the water completely after using)
After complete draining, set the "WASH SELECTOR" at "STRONG" or "SOFT".
If it is set at "DRAIN", it will be rather difficult for the frozen water to melt.
When the water is frozen
Pour hot water below 50
to soak it completely. Then turn the pulsator
with hands gently. Please confirm the drainage
can work normally before next using.
12
into the wash tub
Spin tub frame
Laundries
Below 50
2~3L
Advertisement
Table of Contents
