Replacing The Fuse - Yamaha TW200ET Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
9. Connect and tighten the positive
battery lead to the battery's posi-
tive (+) terminal.
10. Connect and tighten the negative
1
battery lead to the battery's nega-
tive (-) terminal.
2
11. Install the seat.
To store the battery
1. If the vehicle will not be used for
3
more than one month, remove the
battery, fully charge it, and then
4
place it in a cool, dry place.
2. If the battery will be stored for more
5
than two months, check the specif-
ic gravity of the electrolyte at least
6
once a month and fully charge the
battery whenever necessary.
7
3. Fully charge the battery before in-
stallation.
4. After installation, make sure that
8
the battery leads are properly con-
nected to the battery terminals and
9
that the breather hose is properly
routed, in good condition, and not
obstructed.
CAUTION:
If the breather hose is positioned in
such a way that the frame is ex-
posed to electrolyte or gas expelled
from the battery, the frame could
suffer structural and external dam-
ages.
6-29
ECA10600

Replacing the fuse

The fuse holder is located behind panel
B. (See page 6-5.)
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to "OFF" and turn off
all electrical circuits.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage.
2
1
1. Fuse
2. Spare fuse
Specified fuse:
20.0 A
EAU23501