Yamaha TW200ET Owner's Manual page 44

PERIODIC MAINTENANCE AND MINOR REPAIR
bolt, the O-ring,
spring, and oil strainer will fall out.
Take care not to lose these parts.
1
3
2
3
4 2
5
1. O-ring
2. Compression spring
3. Oil strainer
6
NOTE:
Skip steps 4–9 if the oil filter element is
7
not being cleaned.
8
4. Remove the oil filter element drain
bolt to drain the oil from the oil filter
element.
9
compression
1
2
(×2)
1. Oil filter element cover
2. Bolt
3. Oil filter element drain bolt
5. Remove the oil filter element cover
by removing the bolts.
6. Remove the oil filter element and
O-rings.
2
1. Oil filter element
2. O-ring
1
3
1
2
6-9
7. Check the O-ring for damage and
replace it if necessary.
8. Clean the oil filter element with sol-
vent, and then install it.
NOTE:
Check the oil filter element for damage
and replace it if necessary.
9. Install the oil filter element cover by
installing the bolts and the drain
bolt, then tightening them to the
specified torques.
Tightening torques:
Oil filter element cover bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
Oil filter element drain bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
NOTE:
Make sure that the O-rings are properly
seated.
10. Clean the oil strainer with solvent,
and then check it for damage and
replace it if necessary.
11. Install the oil strainer, compression
spring, O-ring and engine oil drain
bolt, and then tighten the drain bolt