Rear Wheel - Yamaha TW200ET Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
Tightening torque:
Axle nut:
90 Nm (9.0 m·kgf, 65 ft·lbf)
1 6. Connect the speedometer cable.
2
3
4
5
6
7
8
9

Rear wheel

To remove the rear wheel
WARNING
G
It is advisable to have a Yamaha
dealer service the wheel.
G
Securely support the motorcy-
cle so that there is no danger of
it falling over.
1. Loosen the axle nut.
2. Remove the brake pedal free play
adjusting nut, and then disconnect
the brake rod from the brake cam-
shaft lever.
3. Turn the drive chain adjusting
plate on each side of the swingarm
fully in direction (a).
6-35
EAU25080
2
EAU25420
EWA10820
(a)
1
1. Axle nut
2. Brake pedal free play adjusting nut
3. Brake rod
4. Brake camshaft lever
5. Drive chain slack adjusting plate
4. Lift the rear wheel off the ground
according to the procedure on
page 6-33.
5. Remove the axle nut, and then pull
the wheel axle out.
6. Push the wheel forward, and then
remove the drive chain from the
rear sprocket.
NOTE:
The drive chain does not need to be
disassembled in order to remove and
install the wheel.
3
4
5