Front Wheel - Yamaha TW200ET Owner's Manual

Front wheel

To remove the front wheel
WARNING
G
It is advisable to have a Yamaha
dealer service the wheel.
G
Securely support the motorcy-
cle so that there is no danger of
it falling over.
1. Disconnect the speedometer ca-
ble from the front wheel.
2. Loosen the axle nut.
1
2
1. Speedometer cable
2. Axle nut
3. Lift the front wheel off the ground
PERIODIC MAINTENANCE AND MINOR REPAIR
EAU24360 according to the procedure on
page 6-33.
4. Remove the axle nut, pull the
EAU24580
wheel axle out, and then remove
the wheel.
EWA10820
CAUTION:
Do not apply the brake after the
wheel has been removed together
with the brake disc, otherwise the
brake pads will be forced shut.
To install the front wheel
1. Install the speedometer gear unit
into the wheel hub so that the pro-
jections mesh with the slots.
1. Speedometer gear unit
NOTE:
Make sure that there is enough space
between the brake pads before insert-
ECA11070
ing the brake disc and that the slot in
the speedometer gear unit fits over the
retainer on the fork leg.
EAU24981
1. Retainer
2. Speedometer cable
1
6-34
2. Lift the wheel up between the fork
legs.
1
3. Insert the wheel axle, and then in-
stall the axle nut.
4. Lower the front wheel so that it is
on the ground.
5. Tighten the axle nut to the speci-
fied torque.
2
3
2
4
5
6
7
8
9