Panasonic CU-E18CKR Service Manual page 73

11. Do not modify the length of the power supply cord or use of the extension cord, and do
not share the single outlet with other electrical appliances. Otherwise, it will cause fire or
electrical shock.
1. The equipment must be earthed. It may cause electrical shock if grounding is not perfect.
2. Do not install the unit at place where leakage of flammable gas may occur. In case gas
leaks and accumulates at surrounding of the unit, it may cause fire.
3. Carry out drainage piping as mentioned in installation instructions. If drainage is not perfect, water
may enter the room and damage the furniture.
1. Selection of the installation location.
Select a installation location which is rigid and strong enough to support or hold the unit, and
location for easy maintenance.
2. Power supply connection to the room air conditioner.
Connect the power supply cord of the room air conditioner to the mains using one of the following
method.
Power supply point shallbe the place where there is ease for access for the power disconnection
case of emergency.
In some countries, permanent connection of this room air conditioner to the power supply is
prohibited.
1. Power supply connection to thereceptacle using a power plug. / Use an approved 16A power plug with earth pin for 2.0HP (E18CK, E21CK)
connection to the socket.
2. Power supply connection to a circuit breaker for the permanent connection. Use an approved 16A circuit breaker for 2.0HP (E18CK, E21CK)
the permanent connection. It must be a double pole switch with a minimum 3 mm contact gap.
3. Do not release refrigerant.
Do not release refrigerant during piping work for installation, reinstallation and during repairing
refrigeration parts. Take care of the liquid refrigerant, itmay cause frostbite.
4. Installation work.
It may need two people to carry out the installation work.
5. Do not install this appliance in a laundry room or other location where water may drip from the
etc.
Attached accessories