Installation - Haier HA1000 User Manual

Installation

Connection of water inlet hose and washing machine
1. Place the water inlet hose nut on the connector
of the water inlet valve.And rotate it clockwise to
screw onto the connector
2. slightly shake the water inlet hose nut to see if
it is tightly and properly fixed.
Water drainage hose
• The height of the terminal of the water drainage hose should
be between 80cm-100cm, the water drainage hose must be
securely placed on the clip on the back of the washing machine.
• Use the water drainage support supplied as an accessory
for proper installation of the water drainage hose .fix the water
drainage hose support with waterproof sring.Do not use an
excessively long water drainage hose and contact the autho-
rized technician if the water drainage hose needs to be
extended.the water drainage hose should not be extended
more than250cm.(longer extension will result in concurrent
water inflow and outflow).The diameter of the extension hose
should be the same as the original hose.
caution:water drainage hose must not be immersed in water.
the original and extension hoses should be tightly connected .
Connection of power supply
Check the following items before connection to the power supply.
• The socket conforms to the maximun power load(The maximum current load of the
socket and power supply cable should not be less than 15A).
• Power supply voltage conforms to the required value.
The power supply socket and the plug of the washing machine are compatible,if they are not
•
compatible ,Refer to a washing machine technician or a Haier designated service point
for power cable replacement.The washing machine should be connected to an earth
before use.
• Supplementary earth cable should not be necessary if the socket is connected to the
earth.
Supplementary earth cable should be installed on the upper back of the washing
•
machine andconnected to an earth if the power supply socket has no earth connection.
water inlet hose nut
connector of water inlet valve
•
•
•
•
5