Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Haier HA600TX
Summary of Contents for Haier HA600TX
-
Page 2: Technical Specification
Technical Specification Item Power supply Maximum working current Water pressure Washing power Spinning power Washing program Washing capacity Heating power Size (HXDXW) Weight Model HA600TX 220V~/50Hz 0.05 (MPa) (kg) 1950 850x550x595 (mm) (kg) -
Page 3: Trouble Shooting
Trouble shooting The following circumstances do not constitute problems. Do not contact the main- tenance service until the problem has been confirmed. Problem The washing machine fails to operate Washing machine does not fill with water The water supply and drainage do not stop Drainage failure Strong vibration during spin... - Page 4 Maintenance 1. Turn of the water and electricity supply after every wash. Open the door to pre- vent the formation of moisture and odors. If the washing machine is left idle for a long period, drain any remaining water in the machine and replace the drainage hose.
-
Page 5: Washing Methods
Washing Methods 4. Washing temperature Setting Set the washing temperature as required, otherwise, set at position * when heating is not needed. 5. Selecting the function button Select function buttons as required (refer to the directions printed on the operation panel) ,otherwise keep all the button released. -
Page 6: Use Of Detergent
Washing Methods 1. Laundry loading Evenly load the laundry in the washing machine and then tightly close the door of the washing machine Note: 1) When first using the washing ma- chine, let it run unloaded for one program to prevent the laundry from being tainted by oil or dirty water from the washing ma- chine. -
Page 7: Water Supply
Preparation 1. Power supply Plug in the power supply 220V~/50Hz. 4. Detergent selection Only special low foam detergent should be used in automatic drum washing machine, form blended or wool fabrics special detergent should be used. dry cleaning solvent should not be used such as trichhloroethylene or alike (caution : load the required amount of deter- gent only). -
Page 8: Program Selection
Program Selection Intense Delicate Delicate Note: "O" means softener liquid detergent can be added when necessary. " " means detergent can be added when neccessary. "X" means no detergent can be added. -
Page 9: Operational Functions
The light will illuminates when the power supply is connected. H Door Lock Light Remember that only when the washer doesn’t work, we can open the door. After the washing program finish,after 3 minutes, when the self-lock meter turn off, we can open the door. -
Page 10: Control Panel
Control Panel A Washing program Turn the knob clockwise to set the desired wash program . Caution: Turn off the power and turn the program knob clockwise for setting desired wash program. B Washing temperature Turn the knob clockwise to set the desired temperature. Temperatures between 30 C-90 lected when the knob is set at *. - Page 11 Power supply voltage conforms to the required value. The power supply socket and the plug of the washing machine compatible,if they are compatible ,Refer to a washing machine technician or a Haier designated service point for power cable replacement.The washing machine should be connected to an earth before use.
- Page 12 Installation As shown in figure1 remove all the packing materials (including the foam base). Remove the packing screws as shown in figure 2. The packing bolts protect the appliance from shock during transportation The steps below should be followed before using the appliance, 1.
-
Page 13: Matters Needing Attention
Matters Needing Attention 3. Never place heavy objects ,a heating applianceor a water container on the top panel of the washing machine. 5. Before washing, do up zippers, buttons ,laces and repair damaged areas,underwear or small articals should be placed in the laundry bag or a pillowslip. - Page 14 Matters Needing Attention 8. The washing machine must not be used in the open or in area of high moisture as water droplets may form on electrical components, Air dry the appliance if the washing machine components become wet. 10. Keep away from heat sources and direct sunlight to prevent plastic and rubber com- ponents from aging.
- Page 15 3. Fuses in the power circuit should be rated for 15A. Refer to a washing machine techni- cian or a Haier designated service point for power cable replacement. 5. Do not use flammable detergent or dry clean- ing agent;...
-
Page 16: Names Of Parts
Names of Parts Detergent distributor Operation button Door Porthole Power supply cable Earth terminal Back plate screw (3) Drainage hose Caution and Warning symbols For your safety, any instructions in this manual with this “Warning” sign shall be strictly followed. For your safety and to prevent damages to the washing machine, any instructions in this manual with this “Stop”... - Page 17 HA600TX Automatic Drum Washing Machine Table of Contents Before using Names of Parts--------------inside front cover Matters Needing Attention--------------------1-3 Installation----------------------------------------4-5 Control Panel---------------------------------------6 Operational Functions------------------------6-7 During using Program Selection--------------------------------8 Preparation-----------------------------------------9 Washing Methods---------------------------10-11 Maintenance Maintenance -------------------------------------12 Trouble Shooting--------------------------------13 Technical Specification---- --------------------14 Wiring Circuit-------------------------------------15...