Preparation Before Washing; Add The Detergent; Put In The Laundries - Haier 50FREE-3 User Manual

1 Preparation before washing

Preparation before washing
1.Connect the water inlet hose and open the water tap .
2.Confirm that the washing machine isearthed reliably . The
insert the powerplug into the receptacle. Do not connect the
earth terminal to the gas pipe and tap water pipe.
3.Put down the drain hose.
Pay attention to followings before washing the laundries
Clear the pocket.
Confirm if
Fasten the
Take out the
there's special
buttons and
coins , sand,
requirment for
zippers.
hairpins etc.
the laundries.
a.Please check if the laundries are applicable for washing.
b.Separate those not colorfast from other laundries.
c.For laundries not waterabsorbing,please put them into water with hands.
d.For laundries with much soil,please remove the soil first.You can add detergent on the
part with serious soil directly.It is much easier to remove the soil by that mean.
e.For laundries likely to get lint ball or with long fiber,please first turn the inside out before
putting them into the water.
f.Do not put the laundries polluted with chemicals directly into the washing machine.

2 Put in the laundries

The capacity of washing and spinning of the machine refer to the largest weight
of the standard laundries under dry condition that can be washed or spun in
one time. One time washing quantity shall be lower than the rated capacity.
The thicknesses, size, type of the cloth will influence the actual washing capacity.
It is suitable for one time washing to put in reasonable amount of laundries and
the laundries can be turned round in washing.
Do not select 4 water level for laundries smaller than 0.8kg, so as to avoid
splashing of water.
When the pulsator is running,
The quantity of
the buttons of the laundries
the laundries
may cause noise. For the
shall not exceed
sake of discretion,please
the rated value.
put the laundries with buttons
The big laundries
into other laundries.
like the jeans
shall be put in
loosely.
8

3 Add the detergent

How to use the whitener
Fill water to decided level. Dilute the whitener
with container. Pour it slowly into the washing
tub.
Avoid using whitener on laundries with color
or pattern as they are prone to lose color.
The whitener shall not touch the laundries
directly.
Refer to the user's manual for the usage and
quantity of the whitener.
For powder whitener, please dissolve it before
use.
Standard usage quantity of the detergent and water
quantity
Laundries Water level Water quantity
quantity(kg)
About 32L
4
1.5~3.3
About 26L
3
2 About 21L
1.5
About 16L
1
How to use the washing
powder
Direct dissolved in the machine
1.Fill water to "1" level.
2.Add the power. Run for 30 seconds to
dissolve it completely.
3.Put in the laundries. Select suitable water level.
The instant dissolving of the washing powder:
1.Prepare warm water of 30 C and a container.
2.Add the powder while stirring to fully
dissolve it.
The powder is more prone to pollute the
laundries than the detergent. Therefore
please use it with proper quantity.
Washing powder with poor quality or not used
for a long period may get blocked. Please
clean the detergent box in time.
Different washing powders have different
dosage. Please refer to the usage manual of
the washing powder for the details.
Concentrated
Common powder
powder
(Add 40g in each
(Add 25g in each
30L water)
30L water)
About 42.7g About 26.7g
About 34.7g About 21.7g
About 28g About 17.5g
About 21.3g About 13.3g
9