Using The Remote Control - Empire Comfort Systems Boulevard VFLB60FP90N-1 Homeowner's Manual

Contemporary linear vent-free gas fireplace models

Hide thumbs

Table of Contents

LEd ANd FIREPLACE WALL CONTROLS

LEd BRIGHTNESS BUTTON

Press the LED Brightness Button to activate the LED lights and

to switch the LED Intensity to High, Medium, Low or Off.

1 – On – High

2 – Medium

3 – Low

4 – Off

Use the Brightness Button in conjunction with the Mode Button to

create unique looks.

Lights will remember the last Mode when turned on again. (After

a power failure, you must reset the lights to the desired Mode.)

Turn off the LED Lights when not in use.

LEd MOdE BUTTON

Press the Mode Button to switch LED light system from

Automatic Color Changes to Individual Colors.

1 – Auto-cycle – Rapid

2 – Auto-cycle – Gradual

3 – Pause Auto-cycle

4 – Deep Blue

5 – Royal Violet

6 – Cardinal Red

7 – Sea Green

8 – Forest Green

9 – Tranquil Blue

10 – White

The transmitter and receiver are radio frequency devices.

Placing the receiver in or near metal may severely reduce

the signal range.

Notice:

•

Turn OFF the main gas supply of the fireplace during

installation or maintenance of the receiver.

•

Place the receiver's 3-position slider switch in the OFF

position during installation or maintenance.

Fire Hazard. The receiver lights the fireplace, which can

turn on suddenly. Keep away from the fireplace burner

when operating the remote system or activating manual

bypass of the remote system.

Property damage Hazard. Excessive heat can cause property

damage. The fireplace can stay lit for many hours. Turn off

the fireplace if it is not going to be attended for any length

of time.

Always place the Transmitter where children can not reach it.

Page 6