Sump Assembly - GE GLDT690T Technical Service Manual

https://appliancetechmanuals.com

Sump Assembly

The sump assembly consists of the
fi
micro- lter, sump clamping nut , sump gasket , and
fi
sump. The lter assembly prevents large particles
from reaching the micro-
prevents small particles from reaching the sump.
fi
The lter assembly rests above the sump and the
fi
micro- lter sits above the sump basin. The clamping
nut holds the sump gasket and sump to the bottom
of the dishwasher. The
and sump clamping nut are accessed from inside
the dishwasher. The gasket and sump are located
under the tub in front of the motor pump assembly .
To remove the sump assembly:
1. Disconnect power.
2. Open the dishwasher door and remove the
bottom rack.
3. Rotate cy lindrical
counterclockwise to remove.
fi
4. Lift steel lter out of tub.
Cylindrical Filter
Steel Filter
fi
5. Lift micro-
Micro-Filter
fi
lter assembly ,
fi
lter and the micro-
fi
lter assembly , micro-
fi
lter 1/ 4-turn
lter out of tub.
Note: The sump clamping nut turns
counterclockwise and may be dif
may be helpful to insert a 3/ 4-in. wide x 4½ -in. long
piece of wood between the clamping nut tabs to
enable y ou to apply suf
factory seal.
fi
lter
6. Remove the sump clamping nut .
7. Remove the sump gasket (not shown) and sump.
fi
lter,
Clamping
Nut
8. Remove the dishwasher from its installation.
9. Lay the dishwasher on its back.
10. Disconnect the thermistor wire harness.
11. Remove the pressure switch hose from the
sump.
Sump
– 29 –
fi
cult to remove. It
fi
cient torque to break the
Tabs
Tabs
Sump
Wire Harness
Pressure Switch Hose