Motor Pump Assembly - GE GLDT690T Technical Service Manual

https://appliancetechmanuals.com

Motor Pump Assembly

The motor pump assembly is located under the tub
behind the sump assembly . The motor utilizes a
start capacitor rated at 10
clockwise (as viewed from the terminal end) and
draws approximately 1 amp at 120 VAC.
The motor pump assembly has an approximate
resistance value of 17
Operation of the motor pump assembly can be
checked by using the service test mode. (See
.)
Test Mode
To remove the motor pump assembly:
1. Disconnect power.
2. Open the dishwasher door and remove the
bottom rack.
3. Remove the dishwasher from its installation.
4. Lay the dishwasher on its back.
Caution:
The clamps are easily damaged during
removal and should not be reused.
5. Disconnect the motor ground wire.
Note: Factory -installed hose clamps are not
reusable. When installing a water inlet valve, drain
pump assembly , motor pump assembly , or sump
assembly , replace the old clamps with new screw-
ty pe hose clamps provided. The screw-ty pe hose
clamps are available separately .
6. Remove clamp and outlet hose.
Outlet Hose
7. Cut off the wire tie and disconnect the motor
wire harness.
8. Remove 2 clamps, pump interconnect hose, and
outlet hose.

fd. The motor rotates

.
Service
Ground Wire
Clamp Part Number
WD01X10322
Wire Harness
9. Remove the Phillips-head screw, lock washer,
and washer that attach the motor bracket to the
back rail.
10. Pull the motor bracket off the motor tab.
– 27 –
Size
15/ 16" to 1-1/ 2"
Interconnect
Hose
Outlet Hose
Wire Tie
Motor Bracket
Back Rail
Motor Tab
Motor Bracket
( Continued next page )