Figure 14. Remove three screws and remove the heat sink
Screw specifications
M2.0 x L4.0
Go to
https://support.lenovo.com/partslookup
part:
Heat sink
Remove the touchpad and the touchpad cable
Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 30
"Remove the battery pack" on page 31
Step 1.
Disconnect the touchpad cable connectors and then remove the cable. Remove two screws.
Figure 15. Remove the touchpad cable and two screws
Screw specifications
M2.0 x L2.0
Step 2.
Open the LCD module and remove the touchpad.
36
Hardware Maintenance Manual
Number of screws
3
to look up the Lenovo part number of the following replacement
Number of screws
2