Advertisement
10 If using the nut plates, starting in one corner of the template, place a nut plate
the previous step.
The other hole
on the nut plate should line up with the inner 4 mm (
5
11 If the 4 mm (
/
in.) hole on the nut plate does not line up with the inner hole on the template, mark the new
32
location.
12 Repeat steps 10 and 11 for each nut plate.
5
13 Using a 4 mm (
/
in.) drill bit, drill the inner holes.
32
14 Remove the template from the mounting surface.
15 Starting in one corner of the mounting location, place a nut plate
lining up the inner and outer holes.
The raised portion of the nut plate should fit into the inner hole.
16 Secure the nut plate to the mounting surface by fastening an included M3 pan-head screw
5
inner 4 mm (
/
in.) hole.
32
17 Repeat steps 15 and 16 for each of the nut plates along the top and bottom of the device.
18 Install the gasket pieces
The pieces of the rubber gasket have adhesive on the back. Make sure you remove the protective liner before
installing them on the device.
19 If you will not have access to the back of the device after you mount it, connect all necessary cables to the
device before placing it into the cutout.
20 Place the device into the cutout.
on the back of the device.
over the hole
5
/
in.) hole on the template.
32
on the back of the mounting surface,
drilled in
through the
3
Advertisement
