SRAM RockShox DebonAir Upgrade Manual page 13

2018 DebonAir and Solo Air: Use your fingers to install the bottom bolt
3
into the air shaft. Firmly pull on the bottom bolt to remove the air shaft
assembly from the upper tube. Unthread and remove the bottom bolt
from the air shaft.
2019-2022 DebonAir: Wrap a shop towel around the end of the air
shaft for extra grip. Push the shaft half way into the upper tube, then
quickly and firmly pull the shaft out to dislodge the seal head. Remove
the air spring assembly from the upper tube.
A build up of negative air pressure may prevent the air spring from
being pulled out of the upper tube. If the air spring is difficult to
remove, use a clean plastic dowel to push the air spring piston down
while pulling the air shaft out.
Spray isopropyl alcohol on the inside and outside of the upper tube
4
and clean it with a shop towel. Wrap a shop towel around a long dowel
and insert it into the upper tube to clean inside the upper tube.
Continue with DebonAir Seal Head Only Upgrade
Continue with DebonAir Spring Installation
if upgrading the seal head on a 2019-2020 DebonAir assembly.
if installing a DebonAir Upgrade kit.
DebonAir
2019-2020 DebonAir
2021-2022 DebonAir
Bottomless Tokens Installation (optional)
DebonAir
2019-2020 DebonAir
2021-2022 DebonAir
13