Setup - Sharper Image LM516 Instructions Manual

Installing Batteries
Batteries will fit tightly. To avoid start-up problems, make sure that the batteries do
not spring free. Be sure to insert batteries into the transmitter(s) first, then the
Weather Center. Initial setup should be done with the transmitter(s) and weather
station in the same room. The transmitter(s) should be permanently mounted only
after the signal reception has been verified.
Remote Transmitter
1. Pull the cylindrical rain cover off the transmitter.
2. Remove the battery cover (located on the back side of the transmitter above
the mounting post and bracket). Press the arrow and slide the battery cover
off.
3. Install 2 AA alkaline batteries, observing the correct polarity.
4. Replace battery cover and place rain cover snugly onto the transmitter.
Weather Center
1. Remove the battery cover (large center panel with writing on it).
2. Install 3 AA alkaline batteries, observing the correct polarity.
3. Do not press any buttons for at least 10 minutes. If a button is pressed before
the Weather Center has received information from the transmitter, no data will
be received from that sensor until reset.
4. Replace battery cover.
Initial Start-Up Sequence
Immediately after the batteries have been installed, the Weather Center will beep
and the LCD will completely illuminate for a brief moment. All information will
then appear in normal mode, with "12:00" as the default time and "1.1" as the
default date (2001 as the year). "DCA" is the default city (Washington, DC, USA),
with the sunrise, sunset, moonrise and moonset times displayed for that city at
that date. The indoor temperature, humidity and barometric air pressure (as 29.91
inHg relative RH) will also be displayed.
There is a satellite icon that appears near the bottom of the LCD to the right of
the "max" remote temperature. This icon informs the user that the Weather
Center is looking for signals from the transmitter(s). Within five minutes the
remote temperature and humidity should be displayed. If not, remove batteries
from all units and repeat battery installation — the remote transmitter(s) first and
the Weather Center second.

Setup

6