Sharper Image LM516 Instructions Manual page 16

To reset the indoor minimum and maximum temperature and humidity, press and
hold IN for at least two seconds.
Outdoor Minimum and Maximum Temperature and Humidity
The Weather Center automatically stores the minimum and maximum outdoor
temperature and humidity. The minimum and maximum values are updated auto-
matically when a new minimum or maximum is recorded or until manually reset.
The outdoor (remote) minimum and maximum temperature values are displayed
below the outdoor temperature display (values are rounded down for minimum
and rounded up for maximum). The temperature alarm mode shares the same
display. When the alarm values are displayed, "ALARM" will be displayed above
the remote temperature. To switch back and forth between views, press the
OUT key.
The outdoor (remote) minimum and maximum humidity values are displayed
below the outdoor humidity display. To reset the outdoor minimum and maxi-
mum temperatures, press and hold CH for at least one second.
Multiple Remote Temperature Sensors
The Weather Center can receive as many as three remote temperature and
humidity sensors.
New remote sensors will need to be added during the initial setup. Insert batteries
into all remotes first, then into Weather Center. A number 1, 2 or 3 will be
assigned to each remote upon setup. To view the different remotes, press CH
briefly. Each remote will have its own minimum and maximum values stored, as
well as its own alarm settings for temperature. Resetting the outdoor minimum
and maximum values will reset all remote transmitters' recordings.
Remote Temperature Alarm
Remote temperature alarm is triggered when temperatures rise above or drop
below temperatures programmed by you.
1. From the normal mode, press the OUT key to toggle between the temperature
alarm and minimum/maximum values. "ALARM" will be displayed above the
remote temperature display to show alarm is activated.
2. Press and hold OUT for two seconds. The low temperature will flash (32°F
default). Press + or - to adjust the temperature from -22°F to +157°F ("- -" if
outside this range). Any value attained below this value will sound the alarm.
3. Press SET to advance to the high temperature alarm. The high temperature set-
ting will flash (86°F default). Press + or - to adjust the temperature from -22°F
to +157°F ("- -" if outside this range). Any value attained above this value will
sound the alarm. Press SET key to return to the normal display mode (or time-
out after fifteen seconds).
Features and Operations
16