Verifying Static Ip Routing - Cisco MDS 9000 Series Troubleshooting Manual

Troubleshooting IP Connections
S e n d c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .

Verifying Static IP Routing

Static routing is a mechanism to configure IP routes on the switch. To verify that the IP routes are still
there, use the sh ip route command. A sample output of the sh ip route command follows.
switch# sh ip route
Codes: C - connected, S - static
Default gateway is 172.17.8.1
C 172.17.8.0/24 is directly connected, mgmt0
S 11.2.36.0/22 via 11.3.36.1, gigabitethernet8/7
C 11.3.36.0/22 is directly connected, gigabitethernet8/7
C 11.3.56.0/22 is directly connected, gigabitethernet8/8
S 11.2.56.0/22 via 11.3.56.1, gigabitethernet8/8
switch#
A sample output of the sh ip route config command follows.
switch# sh ip route conf
switch#
Cisco MDS 9000 Family Troubleshooting Guide
5-4
0 input errors, 0 frame, 0 overrun 0 fifo
144401 packets output, 7805631 bytes, 0 underruns
0 output errors, 0 collisions, 0 fifo
0 carrier errors
Destination Gateway
default 172.17.8.1
11.2.36.0 11.3.36.1
11.2.56.0 11.3.56.1
11.3.36.0 0.0.0.0
11.3.56.0 0.0.0.0
172.17.8.0 0.0.0.0
Chapter 5
Mask Metric
0.0.0.0 0
255.255.252.0 0
255.255.252.0 0
255.255.252.0 0 GigabitEthernet8/7
255.255.252.0 0 GigabitEthernet8/8
255.255.255.0 0
OL-5183-02, Cisco MDS SAN-OS Release 1.3
Troubleshooting IP Storage Issues
Interface
mgmt0
mgmt0