One To Three Fcip Tunnel Creation And Monitoring - Cisco MDS 9000 Series Troubleshooting Manual

Chapter 5 Troubleshooting IP Storage Issues
S e n d c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .

One to three FCIP tunnel creation and monitoring

Figure 5-6
Figure 5-6
The following example shows the configuration of switch MDS1 for three tunnels from one Gigabit
Ethernet port.
MDS1(config)# fcip profile 21
MDS1(config-profile)# ip address 10.10.10.2
MDS1(config-profile)# exit
MDS1(config)# interface fcip 21
MDS1(config-if)# use-profile 21
MDS1(config-if)# peer-info ipaddr 10.10.11.2
MDS1(config-if)# no shut
MDS1(config-if)# exit
MDS1(config)# ip route 10.10.11.0 255.255.255.0 10.10.10.1
MDS1(config)# ip route 10.10.11.0 255.255.255.0 int gigabitethernet 2/1
Now the interface FCIP is created for the second tunnel. The same FCIP profile is used for this example.
A separate FCIP profile can be used for each interface FCIP if desired.
MDS1(config-if)#
MDS1(config-if)# int fcip 23
MDS1(config-if)# use-profile 21
MDS1(config-if)# peer-info ipaddr 10.10.8.2
MDS1(config-if)# no shut
OL-5183-02, Cisco MDS SAN-OS Release 1.3
shows the configuration of switch MDS1 for three tunnels from one Gigabit Ethernet port.
MDS1 Configured for Three FCIP Tunnels
GE 2/1
10.10.10.2/24
Fcip profile 21
ip address 10.10.10.2
Interface fcip 23
use-proficle 21
peer-info ipaddr 10.10.8.2
MDS1
Interface fcip 28
use-proficle 21
peer-info ipaddr 10.10.7.2
Interface fcip 21
use-proficle 21
peer-info ipaddr 10.10.11.2
IP
Network
Cisco MDS 9000 Family Troubleshooting Guide
Troubleshooting FCIP Connections
GE 2/1
10.10.10.2/24
Fcip profile 1
ip address 10.10.8.2
Interface fcip 1
use-proficle 1
peer-info ipaddr 10.10.10.2
GE 2/1
10.10.11.2/24
Fcip profile 1
ip address 10.10.11.2
Interface fcip 1
use-proficle 1
peer-info ipaddr 10.10.10.2
GE 2/1
10.10.7.2/24
Fcip profile 1
ip address 10.10.7.2
Interface fcip 1
use-proficle 1
peer-info ipaddr 10.10.10.2
5-15