Table of Contents
Advertisement
CAUTION
- Pb free solder has a higher melting point than standard solder.
Typically the melting point is 50 ~ 70 °F (30 ~ 40 °C) higher. Please
use a high temperature soldering iron and set it to 700 ± 20 °F (370
± 10 °C).
- Pb free solder will tend to splash when heated too high (about 1100
°F or 600 °C). / If you must use Pb solder, please completely
remove all of the Pb free solder on the pins or solder area before
applying Pb solder. If thisis not practical, be sure to heat the Pb
free solder until it melts, before applying Pb solder.
- After applying PbF solder to double layered boards, please check
the component side for excess solder which may flow onto the
opposite side.
Suggested Pb free solder
There are several kinds of Pb free solder available for purchase. This product uses Sn+Ag+Cu
(tin, silver, copper) solder. However, Sn+Cu (tin, copper), Sn+Zn+Bi (tin, zinc, bismuth) solder
can also beused.
10
Advertisement
Table of Contents
