Panasonic CT-27SL13MUG Service Manual page 102

A-Board - Main chassis
1. Slide the chassis completely out of the guide rails.
2. Stand the receiver on its edge. The underside of the board is
completely accessible for component replacement.
Note:
Some tie-wraps that secure the wire dressings may need to be unfastened for chassis removal.
C-Board - CRT output
The board plugs onto the socket on the CRT neck. To release the Focus wire, use a dull object to
release the tab on the socket (near the wire opening) and carefully pull on the wire. To connect
the focus wire, press on the tab to lock it then insertthe wire in the opening and press on it until it
is fully inserted and locked in place.
Speakers
Each speaker is secured to the cabinet with 4 screws.
NOTE
When reassembling speakers be sure to connect the speaker wires to the correct speaker lead (+)
(-)
9.1. Disassembly for CRT replacement
1. Discharge the CRT as instructed in the "safety precautions".
2. Disconnect the yoke (DY) plug, degaussing coil (DEG) plug from
the main board.
Focus cable release
15