Table of Contents
Advertisement
Available languages
Available languages
RN-F" or "H05VV-F". Check it before every
use for damage, always uncoil it during
use because coiled cords can overheat.
Damaged extension cords should not be
repaired, they should be replaced with an
equivalent type.
■
A power spike causes voltage fluctuations
and may affect other electrical products in
the same power line. Connect the product
to a power supply with an impedance equal
or less than 0.389 Ω to minimize voltage
fluctuations. Contact your electric power
supplier for further clarification.
SHREDDER SAFETY RULES
OPERATION
■
Before starting the product, look into the
feeding chamber to make certain that it is
empty.
■
Keep your face and body away from the
feed intake opening.
■
Do not allow hands or any other part of
the body or clothing inside the feeding
chamber, discharge chute, or near any
moving part.
■
Always be sure of your footing. Keep firm
footing and balance. Do not overreach.
Never stand at a higher level than the base
of the product when feeding material into it.
■
Always stand clear of the discharge zone
when operating the product.
■
When feeding material into the product
be extremely careful that pieces of metal,
rocks, bottles, cans or other foreign objects
are not included.
■
If the cutting mechanism strikes any
foreign objects or if the product should start
making any unusual noise or vibration,
switch the product off and allow the
cutters to completely stop. Disconnect the
product from its power supply, and take the
following steps:
●
inspect for damage;
●
check for and tighten any loose parts;
●
have any damaged parts replaced or
repaired with genuine Ryobi spare parts.
■
Do not allow processed material to build up
in the discharge chute as this may prevent
proper discharge or blockage and can
result in kickback of material through the
feed intake opening.
2
| English
■
If the product becomes clogged, switch
the product off and allow the cutters to
completely stop. Disconnect the product
from its power supply before clearing
debris.
■
Never operate the product if the guards,
covers, collection box, or other safety
devices are defective, not in place, and not
in good working order.
■
If dust is created by the shredding process,
wear a suitable dust mask to prevent
respiratory injury.
■
Do not move or transport the product while
the motor is running.
■
Switch off the product and disconnect from
the power supply whenever you leave the
work area.
■
Do not tilt the product while the motor is
running.
■
You must never modify parts from the
product or use parts not recommended by
Ryobi, this may increase the risk of serious
injury to yourself or others.
■
Always ensure that ventilation openings
are kept clear of debris; otherwise, the
motor may overheat resulting in possible
damage to the product or increase the risk
of fire.
■
Switch off the product before attaching or
removing the collection box.
■
Do not use the product in bad weather
conditions especially when there is a risk of
lightning.
WARNING
Injuries may be caused, or aggravated, by
prolonged use of a tool. When using any
tool for prolonged periods, ensure you take
regular breaks.
TRANSPORTATION AND STORAGE
■
Make sure that the product has been
thoroughly cleaned before storing it in a
clean, dry place, and secured out of the
reach of children.
■
Allow the product to adequately cool down
before storing or transporting.
■
When transporting the product, make sure
it is secured against falling or movement
within the vehicle.
Advertisement
Table of Contents
