Timer On/Off Function - Haier AB142ACBAC Operation Manual

Guide to Operation

Timer ON/OFF Function

Set clock correctly before starting TIMER operation
ON
TEMP
ON
OFF
SWING
1
MODE
FILTER
SET
CLOCK
3
TIMER SLEEP
2
LOCK RESET
Note:
After setting TIMER function,the remote controller displays TIMER time.If you want to see clock time,
just press CLOCK button once it will display clock time (continuously press twice,you can adjust clock,
see page 6 for details), and 5 seconds later it will back to TIMER time.
1.Unit start
After unit start ,select your desired operation mode(operation
mode will be displayed on LCD)
2.TIMER mode selection
Press TIMER button on the remote controller to change TIMER
mode.Every time the button is pressed,display of TIMER mode
changes as follows:
C
TIMER ON
Then select TIMER mode as needed (TIMER ON or TIMER OFF).
And now
3.TIMER setting (press time adjust button)
FAN
Every time the button is pressed , time increases 10 minutes.
If the button is kept pressed ,time will change quickly.
Every time the button is pressed , time decreases 10 minutes.
If the button is kept pressed ,time will change quickly.
It can be adjusted within 24 hours at will.
4
4.Confirm setting
After set correct time,press SET button to confirm time. And now
or
ON
Time displayed: unit starts or stops at X hour X min (TIMER ON
or TIMER OFF)
5.Cancel TIMER mode
Just press TIMER button several times until TIMER mode disappears
Hints:
After replacing batteries or a power failure happens,TIMER setting
should be reset.
Remote controller possesses memory function,when use TIMER
mode next time,just press SET button after mode selection if timer
setting is the same as previous one.
ON OFF
12:00 12:00
AM
PM
TIMER OFF TIMER ON-OFF
or will flash.
OFF
ON
stops flash.
OFF
14
blank
ON OFF
12:00 12:00
AM
PM