Table of Contents
Advertisement
Guide to Operation
Sleep Function
Before going to bed you can press down the SLEEP button and the air conditioner will run by
the comfortable sleeping mode to make you sleep more comfortable.
Before use this function, the clock must be corrected.
Usage of SLEEP function
After unit start,first set running mode and then press SLEEP button once.Mark the air conditioner
have the previous-set sleep time(first power-on or after carrying out sleep function is 1h),the sleep
symbol will appear. Press time button
button is pressed the time increases/decreases 1 hour and ì xh î appears in the humidity
setting part ,ì OFF î appears in ì TIMER OFF î display part and the sleep symbol disappears.
Operation Mode
1.In COOL, DRY mode
One hour after sleeping operation start, the temp.
is 1 C higher than the setting one. After another
hour the temp. rises 1 C and then run continuously
for another 6 hrs and then close. The actual temp.
is higher than the setting one which is to prevent
from being too cool to your sleep.
2.In HEAT mode
One hour after sleeping operation start, the temp.
decreases 2 C lower than the setting one. After
another hour decreases by 2 C more. The temper-
ature will automatically rise by 1 C after an other
3 hrs operation ,and then automatically close after
3 hrs continuous operation.The actual temperature
is lower than the setting one which is to prevent
from being too hot to your sleep.
3.In AUTO mode.
The air conditioner will run in corresponding sleep
operation according to the automatically selected
operation mode.
4.In FAN run
Canít use SLEEP function.
Note:
After setting SLEEP function ,it is forbidden to calibrate clock.
If the set sleep-time does not reach 8 hours, unit will stop operation
automatically after set time is complete.
Set ì TIMER OFF îIn COOL,DRY mode function first, then set SLEEP, unit
will perform sleep function.
After set SLEEP function, the TIMER function cannot be set.
Set ì TIMER ON îIn COOL,DRY mode function first,then set SLEEP, the
sleep function can only be set before TIMER ON time.
After setting SLEEP function,press CLOCK button to show the time; press
TEMP button to show the temperature setting; press again to change the
temperature.
/ , you can choose the time in 1~8 hours.Each time the
SLEEP RUN BEGINS
SETTING T
SETTING T
SLEEP RUN BEGINS
13
SLEEP RUN STOPS
about 6 hrs
increase 1 C
increase 1 C
1 hrs
SHUT DOWN
In COOL,DRY mode
SHUT DOWN
1 hrs
decrease 2 C
1 hrs
decrease 2 C
about 6 hrs
3 hrs
increase 1 C
SLEEP RUN STOPS
In HEAT mode
SWING
MODE
CLOCK
TIMER
OFF
TEMP
ON
OFF
FAN
FILTER
SET
SLEEP
LOCK
RESET
Advertisement
Table of Contents
