Table of Contents
Advertisement
Operation instruction
MODE
CLOCK
SET
TIMER
ON/OFF
3.Set time
Press the time adjusting button
*
Each press, the set time increases 10 minutes. If depress the button, the time will
increase rapidly.
*
Each press, the set time decreases 10 minutes. If depress the button, the time will
decrease rapidly.
This LCD will show the time set, the time can be adjusted within 24h.
(AM stands for morning, PM stands for afternoon).
4.Confirm the time
After calibration of the clock, press SET button to confirm time.
At this time, the
*
The time displayed is: at x oíclock x minutes the unit will be turned on
(TIMER ON) or turned off (TIMER OFF).
Cancel TIMER
Press the TIMER button several times until the TIMER mode display
disappears.
Hints:.
After power failure, the clock should be calibrated again.
The wire controller has memory function, when you use this function for the
second time, if the time set is the same as the previous one, you just need to
choose the TIMER mode then press the SET button to confirm.
Before using TIMER function, calibrate the
clock first (referring to page 3). When you
wake up in the morning, before going back
to home after work or after going to bed, you
FAN
SWING
can let your air conditioner automatically turn
on or turn off.
TEMP
1.Turn on the unit
SET
After turning on the unit, set the desired
SLEEP
working mode.
FILTER RESET
RESET
The LCD of the wire controller will show working
mode. (except for Timer, Sleep, Swing)
2.Set of TIMER mode
Press the TIMER button to change the
TIMER mode, each press the TIMER mode
will change as the following sequence:
AM
TIMER ON
Then choose the timer mode as you need
(TIMER ON or TIMER OFF.)
At this time the
*
or
*
*
will not flash.
ON
OFF
Timer On/Off function
ON
OFF
ON
AM
PM
TIMER OFF
TIMER ON-OFF
*
* *
ON
OFF
Blank
PM
*
or
will flash.
OFF
Advertisement
Table of Contents
