Philips Sonicare DiamondClean HX9392/39 Manual page 14

14
English
Sonicare. The Easy-start feature works in all modes other than
TongueCare mode. This Philips Sonicare model comes with the Easy-
start feature activated.
Activating or deactivating the Easy-start feature
1 Place the handle in the plugged-in charger.
To activate Easy-start:
Press and hold the power on/off for 2 seconds. You hear 2 beeps to
indicate that the Easy-start feature has been activated.
To deactivate Easy-start:
Press and hold the power on/off for 2 seconds. You hear 1 beep to
indicate that the Easy-start feature has been deactivated.
Note: Using the Easy-start feature beyond the initial ramp-up period
is not recommended and reduces Philips Sonicare effectiveness in
removing plaque.
Note: Each of the first 14 brushings must be at least 1 minute in length
to properly move through the Easy-start ramp-up cycle.
Traveling with the appliance
Charging via wall outlet
1 Place the handle in the charging travel case.
2 Plug the USB cord into the wall adapter provided and plug into an
electrical outlet.
- The charge indicator flashes green until fully charged.
Charging via USB
1 Remove the USB cord from the travel plug and insert the USB plug
into an USB port.
- Only use Philips USB wall adapter and USB cable provided.
Use Only UL Listed devices as an alternate method of charging the
toothbrush handle in the travel case (i.e. UL Listed Computer, USB
Hub). The charger is not compatible with previous models of Philips
Sonicare.