Philips Sonicare DiamondClean HX9392/39 Manual page 11

Note: The content of the box may vary based on the model
purchased.
Preparing for use
Attaching the brush head
1 Align the brush head so the bristles point in the same direction as
the front of the handle (Fig. 1).
2 Firmly press the brush head down onto the metal shaft until it
stops.
Note: Philips Sonicare brush heads are imprinted with icons to easily
identify your brush head (Fig. 2).
Note: It is normal to see a slight gap between the brush head and the
handle (Fig. 3).
Charging the appliance
1 Plug the charger into an electrical outlet.
2 Place charging glass (select models) on top of the charging base
and place handle in glass (Fig. 4).
- The charge indicator flashes green until fully charged (Fig. 5).
- Rapid yellow flashing indicates charge is extremely low (fewer
than 3 uses left).
Note: It takes at least 24 hours to fully charge the battery.
This charger is designed to properly charge only one handle at a time.
This charger is not compatible with other models of Sonicare.
Using the appliance
Brushing instructions
1 Wet the bristles (Fig. 6).
2 Apply a small amount of toothpaste on the bristles (Fig. 7).
3 Place the toothbrush bristles against the teeth at a slight angle (45
degrees), pressing firmly to make the bristles reach the gumline or
slightly beneath the gumline (Fig. 8).
Note: Keep the center of the brush in contact with the teeth at all
times.
11
English