Philips Sonicare DiamondClean 300 Series Manual page 13

Note: Each of the first 14 brushings must be at least 1 minute in length
to properly move through the Easy-start ramp-up cycle.
Traveling with the appliance
Charging via wall outlet
1 Place the handle in the charging travel case. (Fig. 13)
2 Plug the USB cord into the wall adapter provided and plug into an
electrical outlet. (Fig. 14)
- The charge indicator flashes green until fully charged. (Fig. 16)
Charging via USB
1 Remove the USB cord from the travel plug and insert the USB plug
into an USB port. (Fig. 16)
- Only use Philips USB wall adapter and USB cable provided.
Use Only UL Listed devices as an alternate method of charging the
toothbrush handle in the travel case (i.e. UL Listed Computer, USB
Hub). The charger is not compatible with previous models of Philips
Sonicare.
Cleaning
Note: Do not clean the brush head, handle, charging base or USB
travel case in the dishwasher. The glass is dishwasher safe.
Toothbrush handle
1 Remove the brush head and rinse the metal shaft area with warm
water. Make sure you remove any residual toothpaste.
Note: Do not push on the rubber seal on the metal shaft with sharp
objects, as this may cause damage.
2 Wipe the entire surface of the handle with a damp cloth.
Note: Do not use isopropyl rubbing alcohol, vinegar or bleach to
clean handle as this may cause discoloration.
Brush head
1 Rinse the brush head and bristles after each use (Fig. 18).
2 Remove the brush head from the handle and rinse the brush head
connection with warm water at least once a week.
13
English