About This Document; General Safety Precautions - STEINEL IR 180 Manual

GB
1� About this document
Please read carefully and keep in a safe place�
– Under copyright. Reproduction either in whole or in part only with our
consent.
– Subject to change in the interest of technical progress.
Symbols
!
Hazard warning!
Reference to other information in the document�
...
2� General safety precautions
Disconnect the power supply before attempting
!
any work on the unit�
• This product must only be installed by a qualified electrician in accordance
with national wiring regulations as defined in VDE 08 29 (DIN EN 5000 90).
• Installed improperly, low-voltage products can cause extremely serious
personal injury or damage to property.
• This product must never be connected to a 230 V AC power supply as it is
intended for connection to a safety extra-low voltage power supply.
• Only use genuine replacement parts.
• Repairs may only be made by specialist workshops.
3� IR 180 / HF 180 KNX
Proper use
– Sensor switch suitable for indoor wall-mounting.
– Intelligent sensor technology automatically switches any type of lamp ON
when the room is entered and OFF again after the preset time.
IR 180 KNX
The IR 180 KNX is equipped with a pyro sensor which detects the invisible heat
emitted by moving objects (people, animals etc.). The heat detected in this
way is converted electronically into a signal that switches a connected load ON
(e.g. a light). Heat is not detected through obstacles, such as walls or panes of
glass. Heat radiation of this type will, therefore, not trigger the sensor.
- 16 -
HF 180 KNX
The HF 180 KNX is an active motion detector. It responds to the slightest
movement regardless of temperature. The integrated HF sensor emits
high-frequency electromagnetic waves (5.8 GHz) and receives their echo.
In response to the slightest movement in the detection zone, the change in
echo is perceived by the sensor. A microprocessor then issues the "switch
light ON" switching command, for example. Detection is possible through
doors, panes of glass or thin walls.
The IR 180 / HF 180 KNX also indicates the temperature and humidity levels
measured. These values are transmitted via the KNX bus.
Optionally, all function settings can be made via the RC6, RC7 remote controls
as well as the Smart Remote. (➜ "6� Accessories")
Package contents IR 180 KNX (Fig� 3�1)
Package contents HF 180 KNX (Fig� 3�2)
Product dimensions IR 180 / HF 180 KNX (Fig� 3�3)
Product components (Fig� 3�4)
A Rocker switch
B Cover
C IR 180 KNX lens / HF 180 KNX cover
D Removal slot
E Programming button
F Sensor module
G Status LED
H Temperature / humidity sensor
I Surround
J Metal frame
4� Mounting
• Check all components for damage.
• Do not use the product if it is damaged.
• Select an appropriate mounting location, taking the reach and motion
detection into consideration (Fig� 5�1).
Note for IR 180:
The mounting location should be at least 1 m away from any lights because
heat radiated from these may activate the system.
• Switch OFF power supply. (Fig� 4�1)
• Disconnect sensor module from surround. (Fig� 4�2)
• Screw on support ring with box fixing screws. (Fig� 4�3)
• Connect plug-in connectors. (Fig� 4�4)
• Switch ON power supply. (Fig� 4�6)
- 17 -