Installation Instructions; Before You Begin; Pro Chimney Hood 6'' Duct Cover Extension - Thermador CHMHP366W Installation Instructions Manual

Installation instructions

Before you begin

Before you begin read these instructions carefully.
9 CAUTION
Before installing, turn power OFF at the service panel.
Lock service panel to prevent power from being
turned ON accidentally.
Proposition 65 Warning
This product may contain a chemical known to the State of
California, which can cause cancer or reproductive harm.
Therefore, the packaging of your product may bear the
following label as required by California:
STATE OF CALIFORNIA PROPOSITION 65 WARNING:
:
WARNING
Cancer and Reproductive Harm -
www.P65Warnings.ca.gov
IMPORTANT: Secure the hood to the wall before installing
the duct cover extension. Follow the hood's installation
instructions before securing the extension.
Removing the protective film
1. Carefully remove the protective film from the duct
cover and hood assembly prior to the start of the
installation.
2. Use one hand to maintain the duct cover steady while
the other hand removes the protective film.
Page. 4
Pro Chimney hood 6'' duct
cover extension
Compatible hood models
Duct cover extensions fill the space between the hood
and ceiling of 8 ft. (2.4 m) and 9 ft. (2.7 m) ceilings.
Model
HPCN36WS
HPCN48WS
Securing the Pro Chimney hood 6'' duct cover
extension
1. Installation of the hood should maintain a minimum
height of 30'' (762 mm) from the bottom of the hood
to the cooking surface. To determine placement of the
hood with a duct cover extension, the height of the
extension must be calculated (see the hood's
installation instructions).
2. From inside of hood, screw the supplied 5/8'' (16 mm)
sheet metal screws through the holes on each side
and along the front into bottom of the duct cover
extension, as shown in below. Screw quantity is
dependent on hood size.
The duct cover extension is supported by the hood.
6'' extension
CHMHP366W
CHMHP486W