Parts Supplied; Installation Instructions - Thermador RECHMWB30 Installation Manual

Parts Supplied

1 - Hardware bag
• 4 - 4x8 mm installation screws
• 4 - 4x12 mm installation screws (C)
2 - Charcoal Filter
1 - Air deflector

Installation Instructions

Range Hood Model
HMWB30WS
HMWB36WS
The Installation of the Recirculation kit affects the installa-
tion of the hood, so take into consideration the following
steps.
Cabinet or soffit preparation when installing the
recirculation kit.
For cabinet or soffit preparation take into consideration that
there's no need to provide cutouts on walls for vertical or
rear air discharge, since there is no need to install any Duct.
See the figure for Conduit passage cut-out.
Cabinet front
Bottom of
12" min
Cabinet or
Soffit
Center
Rear
Wall
Hood Width min.
NOTE: The height of the hood with the recirculation kit
installed increases from 11" to 15".
Check that there is enough clearance and that minimum
height from the countertop to the bottom of the hood is
30" (762 mm).
Hood Preparation
The transition must not be installed, since no ducting is
necessary.
Page 4
Recirculating Kit
RECHMWB30
RECHMWB36
A
4" x 4"
cut out for
conduit
4 7 /
passage
Line
Wall Mount Installation
First install deflector on top of the hood then install to the
wall:
1. Fit four screws C on bottom of the deflector, do not
tighten completely.
C
2. Install the deflector on top of the hood so that screws C
go respectively into Side Slots on top of the hood and
Side Slots on bottom of Deflector, slide the deflector
frontward until stops.
B
"
8
3. Tighten the four screws C from inside of the hood.
NOTE: You must uncover the installation holes from the
inside of the hood.
4. Fit the 4x8 mm screws, from inside the hood through
point B to final assembly Deflector to the hood.
5. Proceed to install hood as described on the Installation
Manual.
C
C
B
B
C