Port Names When Using The Vendor Driver; Connecting A Usb Flash Drive; (Usb Memory Port); Formatting A Usb Flash Drive (Format Usb Memory) - Roland JUPITER-X Owner's Manual

JUPITER-X Owner's Manual Ver. 3.0 and later

Port Names When Using the VENDOR Driver

Audio input device
Device Name Port Name
IN MIX (mixed output of the JUPITER-X)
IN 1 (output of the JUPITER-X's part 1)
IN 2 (output of the JUPITER-X's part 2)
IN 3 (output of the JUPITER-X's part 3)
JUPITER-X
IN 4 (output of the JUPITER-X's part 4)
IN 5 (output of the JUPITER-X's part R)
IN MIC (output of the signal that is input from the JUPITER-X's MIC
IN jack)
Audio output device
Device Name Port Name
OUT (USB audio input to the JUPITER-X)
JUPITER-X
OUT MIC (treated as mic input to the JUPITER-X)
MIDI input/output device
JUPITER-X
MIDI IN
JUPITER-X DAW CTRL
JUPITER-X
MIDI OUT
JUPITER-X DAW CTRL
* DAW CTRL is not used for normal MIDI communication.
24

Connecting a USB Flash Drive

(USB MEMORY Port)

You can connect a USB flash drive here.
Formatting a USB Flash Drive
(FORMAT USB MEMORY)
NOTE
5 If the USB flash drive contains important data, be aware that this
operation erases all data from the drive.
1.
Press the [MENU] button.
2.
Use the [1] knob to select "UTILITY", and then press the
[ENTER] button.
You can also make this selection by using the
instead of the [1] knob.
3.
Use the [1] knob to select
then press the [ENTER] button.
A confirmation message appears.
If you decide to cancel, press the
4.
To execute, use the [2] knob
the [ENTER] button.
When formatting is complete, the screen indicates
* Never turn off the power or disconnect the USB flash drive during a
process, such as while the "Executing..."

Backup/Restore

Backing up data to USB flash drive
Here's how to back up user data to a USB flash drive.
Data that is backed up
5 All scene data (including vocoder and arpeggio settings)
5 User tone data
5 System settings (including system effects)
1.
Press the [MENU] button.
2.
Use the [1] knob to select "UTILITY", and then press the
[ENTER] button.
You can also make this selection by using the
instead of the [1] knob.
3.
Use the [1] knob to select "BACKUP", and then press the
[ENTER] button.
The BACKUP NAME screen appears.
4.
Use the PAGE [<] [>] buttons
the [2] knob to change the file name.
5.
When you've specified the file name, press the
button.
A confirmation message appears.
If you decide to cancel, press the
USB flash drive
PAGE [ ] [ ] buttons
"FORMAT USB MEMORY", and
[EXIT] button.
to select "OK", and then press
"Completed!"
display is shown.
(BACKUP)
PAGE [ ä ] [ å ] buttons
to move the cursor, and use
[ENTER]
[EXIT] button.