HP xw4400 Service And Technical Reference Manual page 111

3. Pull the processor 3 straight out of the socket. .
Figure 4-56
CAUTION
CPU socket.
NOTE
To replace the processor:
1. Disconnect power from the system
access panel
the processor
2. Raise the processor socket handle fully (the full swing angle of the lever is approximately 90
degrees).
CAUTION
the processor in the socket to avoid bending pins.
ENWW
Raising the processor socket handle
Avoid bending the protrusions in the CPU socket. This mishandling can damage the
Store the processor in a safe place where it will not be damaged.
(Side access panel on page
(Processor on page
Processor pins are delicate and bend easily. Use extreme care when placing
(Predisassembly procedures on page
66), the CPU heatsink
100).
Steps for removal and replacement of components
60), remove the side
(CPU heatsink on page 98), and
101