HP xw4400 Service And Technical Reference Manual page 107

2. Place the hard drive in the bracket 1 and secure with American National screws 2 as shown in the
following illustration.
Figure 4-51
3. Screw four screws to the bracket 1. Align the screws with the grooves in the optical drive bay and
slide the drive in 2 the chassis.
Figure 4-52
4. Connect the data cable to the hard drive 1 and to the system board 2. SATA installation is shown.
ENWW
Installing hard drive into bracket
Installing hard drive into optical drive bay
Steps for removal and replacement of components 97