Toshiba SMMS-u MMY-MUP0801HT8 Quick Reference page 21

When switching from the wired remote controller (RBC-ASCU11-C)
Basic procedure
Be sure to stop the air conditioner before
making settings.
(Change the setup while the air conditioner
is not working.)
1
Push and hold menu button and [
button simultaneously for 10 seconds or more.
• After a while, the display flashes as shown in the figure.
"ALL" is displayed as outdoor unit numbers during initial
communication immediately after the power has been
turned on.
2
Each time [ ] [
outdoor unit numbers in the group control
change cyclically. Select the outdoor unit to
change settings for.
• The fan of the selected outdoor unit runs. The outdoor
unit can be confirmed for which to change settings.
3
Push OFF timer button to confirm the selected
outdoor unit.
4
Push the menu button to make Code No. [∗∗ ∗∗ ∗∗ ∗∗ ∗∗] flash.
Change Code No. [∗∗ ∗∗ ∗∗ ∗∗ ∗∗] with [
5
Push the menu button to make Set data [∗∗∗∗
Change Set data [∗∗∗∗
6
Push OFF timer button to complete the set up.
• To change other settings of the selected outdoor unit, repeat from Procedure
7
When all the settings have been completed, push ON/OFF button to finish the settings.
(Return to the normal mode).
" " flashes and then the display content disappears and the air conditioner enters the normal stop
SETTING
mode. (The remote controller is unavailable while "
• To change settings of another outdoor unit, repeat from Procedure
] setting button is pushed,
] [
∗∗∗∗] with [ ] [
∗∗∗∗ ∗∗∗∗ ∗∗∗∗
3,6
4,5
] setting
Outdoor unit No.
] setting button.
∗∗∗∗] flash.
∗∗∗∗ ∗∗∗∗
∗∗∗∗
] setting button.
" is flashing.)
SETTING
– 21 –
1 7
Set data
4
.
1
.
2,4,5
Code No.