HP rx5670 Hardware Installation Manual page 42

Cable Connections
Core I/O Connections
Configuring Management Processor LAN Information
LAN information includes the management processor network name, the management processor IP address,
the management processor subnet mask, the management processor gateway address, and the Web Console
port number.
To set the management processor LAN IP address:
1. At the management processor menu prompt (MP>), enter LC (for LAN configuration) and press the
Return/Enter key.
The screen displays the default values and asks if you want to modify them. It is good practice to write
down the information, as it may be required for future troubleshooting.
Figure 3-2 The LC Command Screen
LC
This command allows you to modify the LAN configuration.
Current configuration:
IP Address: 127.0.0.1
MP Host Name:
Subnet Mask: 255.255.255.0
Gateway:
Web Console Port Number: 2023
Do you want to modify the LAN hardware configuration? (Y/[N])
NOTE The value in the "IP address" field is set at the factory. The customer must provide the
actual management processor LAN IP address.
2. At the prompt, Do you want to modify the Lan hardware configuration?, enter y.
The current IP address is shown; then the following prompt appears: Do you want to modify it? (Y/[N])
3. Enter y.
4. Enter the new IP address.
5. Confirm the new address.
6. Enter the management processor Network Name.
This is the host name for the management processor LAN. The name can be as many as 64 characters,
and include alpha numerics, - (dash), _ (under bar),. (period), or a space.
7. Enter the LAN parameters for Subnet mask and Gateway address, and Web Console Port Number.
8. Once step 7 is completed, the system will prompt for changes to the LAN hardware configuration. It is
recommended that this prompt be answered with no by entering n.
9. The system will now indicate that the LAN settings have been updated and that the MP must be reset to
initiate these changes. At the management processor menu prompt (MP>), check the LAN parameters
and status with the LS command to confirm the new LAN settings. After confirmation, use the R option
of the XD command to reset the MP.
42
Chapter 3