HP rx5670 Hardware Installation Manual page 19

Installing Additional Components
Installing Power Supplies and Internal Disk Drives
1. Grasp the handle located at the right edge of the Front Bezel and pull out. The Front Bezel will swing
away from the chassis.
Figure 2-1 hp server rx5670 (front view)
Installing HotSwap Power Supplies
Power Supply Load Order
There is no specific load order requirement for HotSwap Power Supplies. However, the supported
configuration of an hp server rx5670 requires a minimum of two supplies be installed. A third, optional
HotSwap Power Supply, may be installed to provide N+1 capability.
The right side HotSwap Power Supply is identified as P0, the center HotSwap Power Supply is identified as
P1, and the left HotSwap Power Supply is identified as P2. Each HotSwap Power Supply requires a separate
power cord be installed in the appropriate power cord receptacle located at the rear of the chassis.
Installing a HotSwap Power Supply
To install a HotSwap Power Supply, perform the following steps:
WARNING Be careful when installing a HotSwap Power Supply. It is heavier than it appears.
19
Chapter 2