Connecting To Optional Equipment - Toshiba SD-520ESE Service Manual

Connecting to Optional Equipment

You can enjoy high quality dynamic sounds by connecting the DVD player to
optional audio equipment.
• For connection to your TV, see "Connecting to a TV"
– .
18 20
• For details of output sound, see
• This section uses the following reference marks.
: Front speaker
: Rear speaker
: Sub woofer
: Center speaker
: Signal flow
Notes
• DO NOT connect the BITSTREAM/PCM (DIGITAL)
AUDIO OUT jack of the DVD player to the AC-3 RF input
of a Dolby Digital Receiver. This input on your A/V
Receiver is reserved for Laserdisc use only and is
incompatible with the BITSTREAM/PCM (DIGITAL)
AUDIO OUT jack of the DVD player.
• Connect the BITSTREAM/PCM (DIGITAL) AUDIO OUT
jack of the DVD player to the "DIGITAL (OPTICAL)" or
"DIGITAL (COAXIAL)" input of a Receiver or Processor.
• Refer to the owner's manual of the connected equipment
as well.
• When you connect the DVD player to other equipment, be
sure to turn off the power and unplug all of the equipment
from the wall outlet before making any connections.
• The output sound of the DVD player has a wide dynamic
range. Be sure to adjust the receiver's volume to a
moderate listening level. Otherwise, the speakers may be
damaged by a sudden high volume sound.
• Turn off the amplifier before you connect or disconnect the
DVD player's power cord. If you leave the amplifier power
on, the speakers may be damaged.
.
43
Warning
• When you are connecting (via the BITSTREAM/PCM
(DIGITAL) AUDIO OUT jack) an AV decoder that does
not have Dolby Digital or MPEG2 decoding function, be
sure to set "Digital Output" to "PCM" from the on-screen
displays . Otherwise, high volume sound may
56 62
damage your hearing as well as the speakers.
• DO NOT play DTS-encoded discs when you are
connecting an AV decoder that does not have DTS
decoding function.
• When playing DTS-encoded discs (audio CDs),
excessive noise may be output from the analog audio
output jacks. To avoid possible damage to the audio
system, you should take proper precautions when the
analog audio output jacks of the DVD player are
connected to an amplification system. To enjoy DTS
Digital Surround™ playback, an external 5.1 channel
DTS Digital Surround™ decoder system must be
connected to the BITSTREAM/PCM (DIGITAL) AUDIO
OUT jack of the DVD player.
21