B_configure.doc 104 Tue Jul 2 15:27:17 1996
Figure 27
CAUTION:
Changing Your Workstation's Hardware Configuration
Installing Storage Devices
Storage Device Cable Routing
When you install your storage device, be aware of the suggested cable rout-
ing paths as indicated in the cable routing label that is affixed to the top of
the storage tray.
Removing the Disk Tray
Perform the following procedure to remove the storage tray from the system
unit:
1 Remove the storage tray retaining screw, as shown in Figure 27.
2 If installed, remove any locking device from the storage tray security loop on the
rear of the system unit.
3 Place your fingertips in the groove on the bottom of the storage tray bezel. See
Figure 27.
Retaining Screw
Removing the Storage Tray
4 Slide the storage tray completely out of the system unit.
Be sure to support the storage tray from underneath while sliding it out of
the system unit.
104