Closing The System Unit Front Panel - HP Visualize B1000 Owner's Manual

4. Swing the panel outward on its left snap hinges until the panel comes
free and place the front panel in a location where it cannot get
broken.

Closing the System Unit Front Panel

Perform the following steps to close the system unit.
1. Locate the hinges on the left side of the front panel, and insert them
into the holes located along the left edge of the system unit.
2. Rotate the front panel inward until you hear the two latch buttons
snap in place. The front panel is now closed. If there is a need to lock
the front panel, use the system unit keys that came with your system
to lock the panel. These keys are located inside the front bezel below
the floppy disk drive.
3. Plug in the system unit power cord, and power on the system.
Chapter 5
Changing Your Computer Hardware Configuration
System Unit Front Panel
99