Cpu Version Update - Philips 170T4 Service Manual

X 83 170T4
Go to cover page
System and equipment requirements
1. An i486 (or above) personal computer or compatible.
2. Microsoft operation system Windows 95/98 is must .
3. A/D Alignment kits (3138 106 10079):
Inclusion : a. Alignment box x1 (as Fig.1)
b. Printer cable x1
c. (D-Sub) to (D-Sub) cable x1
Note: The alignment box has already build-in a batteries socket for
using batteries (12V) as power source. Pull out the socket by
remove four screws at the rear of box. Please do not forget that
remove batteries after programming. The energy of batteries can
only drive circuits for a short period of time.
PC
DC Power
8~12 V
~ ~
To
Monitor
Printer
Port
To PC
The updated firmware of CPU => as shown
in Fig. 3
.
Extract the eight files from IIC170T4.ZIP to C:\IIC170T4\
The IIC170T4.ZIP file (3138 106 10328) Including the
1.170T4.hex
2.170T498_Flash.BAT
3. 170T498_Flash_IIC.BAT
4 .FlashMenu .hex
5.isp_philips.exe
6.ISP98.exe
7.T498_Flash_IIC.bat
8.XT_OSD_Font.bin
IIC170T4\
Fig. 3 Fig. 3
Firmware upgrade for CPU
Fig. 1 Fig. 1
D-Sub connector
Fig. 2 Fig. 2
as Fig. 3 .
Execution files => as shown in Fig. 4
1.After double clicking the 170T498_Flash.bat
This window:as Fig.4. Attention :The monitor was power off for
a while during this period.
²
3.The message No mismatch
Access Factory Mode
² ² & ²
In pc mode press menu
Monitor will enter factory mode . The Power off /on to leave factory
mode.
A/D Alignment Kits - Digital connection A/D Alignment Kits - Digital connection
Fig. 5 Fig. 5
Check Firmware version : example as below.
170T4 AP V2.00 031201
icon, you will see
²
means complete the process.
²
down key together over 10 seconds.
<
======
Factory mode indicator
Fig. 4 Fig. 4