Table of Contents
Advertisement
6
170T4
Go to cover page
C) Connecting to progressive DVD/Setup Box through YPbPr
component input (while monitor is not connected to a PC)
1. Using the supplied YPbPr to VGA adapter cable, connect the
YPbPr end to the COMPONENT VIDEO OUT terminal of
progressive DVD/Setup Box, and connect the other end to the
VGA connector on the back of the monitor.
2. Connect the RCA cable to AUDIO (L) and AUDIO (R) to the
corresponding audio out terminals on DVD/Setup Box, and the
Other end to the PC AUDIO IN connector on the back of the
monitor.
D) Connecting to TV/CATV
1. Connect an antenna or CATV cable to the antenna port of tuner
Box.
Using the Cable Management
1) Remove the arm box's top cover.
Press the center of the cap and open the cap from sides (Do not
attempt to open the cap from the top or the bottom)
2) Place the cables inside the arm box.
3) Replace top cover.
Installation
Accessory Pack
Advertisement
Table of Contents
