Table of Contents
Advertisement
Filters and maintenance
Activated carbon filter:
For neutralizing odours in recirculating mode.
Caution:
As the filter becomes more and more saturated with
grease, there is an increased risk of fire and the
function of the hood may be impaired.
Important:
Change the activated carbon filter promptly to pre-
en
vent the risk of fire from the accumulation of heat
when deep-fat frying or roasting.
These filters are not washable and cannot be regen-
erated, and must be replaced when the C-sign ap-
pears on the display or approximately every year of
operation, or more frequently with heavy usage.
Activation of the alarm signal
In the recycling version hoods the filter satura-
tion alarm must be activated during the installa-
tion or later.
Switch off the hood and the lights.
Disconnect the hood from the mains supply.
When restoring the connection press and hold
B-key.
When releasing the key two rotating rectangles
appear on the display.
Within 3 seconds press the B-key until a flash-
ing confirmation appears on the dispaly:
2 flashes with C-sign - charcoal filter satu-
ration alarm ACTIVATED
1 flash with C-sign - charcoal filter satura-
tion alarm DEACTIVATED.
Replacing the activated carbon filter
Reset of the alarm signal
Switch off the hood and the lighting.
Press the E-key until the display is unlit.
Replacing of the filter
Open the ducting panels pulling them down-
Open the ducting panels pulling them down-
wards.
Remove the metal grease filters.
7
Filters and maintenance
Remove the saturated charcoal filter by releas-
ing the fixing hooks.
Fit the new filter and fasten it in its correct
position. Filter can be ordered at the customer
service
Put the metal grease filters in their seats.
Close the comfort panels.
Disposal of the old activated carbon filter:
Activated carbon filters do not contain any
harmful substances. They can be disposed of
as residual waste.
Advertisement
Table of Contents
