Table of Contents
Advertisement
72639b-0920.qrk 12/6/00 9:26 AM Page 5
8
Pedal Hub
Pedal Hub
• Turn the front wheel assembly over.
• Insert a pedal hub onto the top of the pedal axle and into
the hole in the center of the front wheel.
• Insert the remaining pedal hub below the pedal axle and
into the hole in the center of the front wheel.
9
• Push the pedal hubs into the center of the front wheel until
they are flush with the surface of the front wheel.
10
• Insert a lock washer into the slot in the pedal. Make sure
the raised tabs on the lock washer are facing the
"closed" or outside end of the pedal.
• Insert the other lock washer into the other pedal.
Assembly
Assembly
11
Pedal Axle
• Place a scrap block of wood under the front wheel assembly.
• Fit a pedal on the pedal axle.
• With the lock washer centered over the pedal axle end, tap
the pedal with a hammer until it is secure.
Pedal Hubs
• Repeat this procedure to attach the other pedal to the other
end of the pedal axle.
12
Fork Cover
Lock Washer
Raised Tabs
Pedal Axle
Slot
• Place the front wheel assembly between the fork arms.
Make sure the pedal axle fits into the groove at the bottom
of each fork arm.
• Place a fork cover over the pedal axle on one fork arm.
Closed (Outside) End
of Pedal
• Insert two #8 x
the fork arm. Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
• Repeat this procedure to attach the other fork cover
to the other fork arm.
5
Front Wheel Assembly
SHOWN ACTUAL SIZE
3
/
" screws through the fork cover and into
4
Lock Washer
(Inside)
Pedal
Pedal Axle
Front Wheel
Assembly
Scrap Block
of Wood
Fork Arms
Groove
#8 x
3
/
" Screw – 4
4
Advertisement
Table of Contents
