Table of Contents
Advertisement
ENGLISH
16
Problem
I experience pain when
I use the breast pump.
The breast pump is
scratched.
The breast pump does
not work and the on/off
button flashes.
I do not feel any suction. Check if you have assembled the breast pump correctly by following
I need to replace the
silicone tube, but do not
know how to remove it.
Solution
Stop using the breast pump and consult your breastfeeding advisor.
If the pump body does not come away easily from the breast, it may
be necessary to break the vacuum by placing a finger between the
breast and the massage cushion.
In case of regular use, some light scratching is normal and does not
cause problems. However, if a part of the breast pump becomes badly
scratched or if it cracks, stop using the breast pump and contact the
Philips Consumer Care Centre to obtain a replacement part. Be aware
that combinations of cleaning agents, sterilising solution, softened
water and temperature fluctuations may, under certain circumstances,
cause the plastic to crack. Avoid contact with abrasive or antibacterial
detergents as these can damage the plastic.
First check if you have assembled the breast pump correctly and make
sure that there is no kink in the tube. If you are using SCF332 with
batteries, replace the batteries according to the instructions in chapter
'Preparing for use', action 5. If you are using SCF334 or SCF332 on
mains electricity, check to make sure you are using the adapter that
was supplied with the product. If the problem persists, contact the
Consumer Care Centre in your country.
the steps in chapter 'Preparing for use'. Make sure the silicone tube is
firmly attached to the motor unit and to the cap and diaphragm.
To remove the tube, grab it close to the motor unit and pull while
twisting it. To reconnect the tube, ease the tube back onto the
connector on the motor unit with a slight twisting motion. Make sure it
is securely attached.
Advertisement
Table of Contents
